Support Topic

Setup Step 7: Programme the Collar Receiver for Multiple Dog Operation

Additional SportDOG® Add-A-Dog® receiver(s) must be purchased to train additional dogs.

TWO OR THREE DOG OPERATION

  1. Programme the Remote Transmitter to mode 5 in either the Toggle Switch up or the Toggle Switch down position.
  2. Programme the first Collar Receiver.
    • Turn the Collar Receiver off.
    • Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin its normal flashing. If this occurs, start over and repeat from 1.
    • After the Receiver Indicator Light has turned off, release the On/Off Button.
    • Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You may need to hold both units 0.6 - 0.9 metres from each other. If the Receiver Indicator Light does not flash 5 times, start over and repeat from 1.
  3. Programme the second Collar Receiver using step 2 above, but using the Lower Button in place of the Upper Button.
  4. Programme the third Collar Receiver using step 2 above, but using the Side Button in place of the Lower Button.
Products related to this Support Topic:

_en-fi