![{img_feature_title_en-nz}](/intl/images/categories/SDF-CT_a2_277-227x227.jpg)
Troubleshooting
- I have a break in the Boundary Wire.
- The collar has to be held on top of the Boundary Wire to activate, or it does not activate at the Boundary at all.
- The Collar Receiver is beeping, but the dog is not responding to the stimulation.
- The Power Light is on, the Loop Indicator Light is off, and the Fence Transmitter loop alarm is sounding.
- How do I check the fuses in my transmitter?
- The Collar Receiver activates inside the house.
- The Collar Receiver is not beeping or stimulating.
- The Collar Receiver will not change stimulation levels.
- Why are my Power and Loop Indicator Lights off?
- The fuses blow when they are replaced.
- Why do I have an inconsistent signal on my boundary?
- My Transmitter is not lighting up any longer.
- What is a Surge Protection Kit?
- Can I twist one wire to make a gate or safe area that my dog can cross?
- Can I use the system with an existing fence?
- How do I fit the collar properly?
- How wide are the warning and stimulation zones?
- Does the Range Adjuster knob tell me how wide my Boundary Width will be?
- What kind of wire will I need, and how do I splice the wires together?
- What level should I use for my dog?
Setup
- Installation Step 1: Locate and Place the Fence Transmitter
- Installation Step 2: Lay Out the System
- Installation Step 3: Position the Boundary Wire
- Installation Step 4: Connect the Wires to the Fence Transmitter
- Installation Step 5: Prepare the Collar Receiver
- Installation Step 6: Set the Boundary Width and Test the Collar Receiver
- Installation Step 7: Install the Boundary Wire
- Installation Step 8: Place the Boundary Flags
- Installation Step 9: Fit the Collar Receiver